Advocate Bespoke Jacket (30 – 48 size range)


Our bespoke jacket is made to your personal specifications and cut according to traditional design and crafted from the same material as your robe. To personalise your garment, you can choose your own coloured lining to suit your style and add extra flair. The jacket is styled like a rounded vest and meticulously crafted for lightness, comfort and durability. It gives a dapper and professional appearance in its simplicity.

Coloured Lining of your choice
Covered Buttons

Tailoring: 4-8 weeks
Colour: Black
Outer: Breathable Cubir Crepe
Reverse: 100% Satin
Button Enclosure
Signature Details: One front broad welt pocket, two double welt pockets below waistline, button details on sleeve cuff.
Dry Clean Only
Made In South Africa


To choose the correct size for you, measure your body as follows:

  • Measure from the top of your head to the ground with your feet together.

    Wrap the tape measure under your armpits, around the fullest part of your chest. Always remember to keep a finger inside the tape to make sure it is not too tight.

    Wrap a tape measure around your abdomen, just above the top of the hip bones. Make sure the tape measure is even and level all the way around your waist. Pull the tape measure to be snug, with one finger inside the tape for movement.

    Let your arm hang by your side. Measure the circumference of your bicep, but don't flex.

    Your back length measurement is taken from the top of your collar to approximately 50mm below your belt or trouser waistband.

    The sleeve length is being measured from the edge of your shoulder down to where you would like the sleeve to end. Stand relaxed with both arms hanging loosely down the sides.

    Length (HSP) is measured from the highest point on the shoulders to the bottom of the hemline where the two front points (V) meet of the jacket. Please ensure that your white shirt will not show. The measurement will most likely be slightly below your belt / trouser waistband. This measurement will be slanted as per the technical drawing reference above.

Add to Favourites
Add to Favourites